Analyzer Instruments

My general problem - I recorded triggered raw data from about 20 electrodes. If I replay this file and try to analyze data from only one electrode with just Analyzer and Display instruments (which is the minimum I need), I still get the following error message:

"System is at its performance limit and cannot process all data. Try to do 1 or more of the following: (i) remove unused displays, (ii) make displays smaller and view only 1-6 channels, (iii) remove analysis instruments and do off-line analysis. Please watch the status bar for information on system load."

Please take a look at the Analyzer window settings: I suppose the window is not set in the "start on Trigger" mode nor has there been an anlyzer region (window extent) been identified.

best regards

Dr.Michael Fejtl, CSO
Multi Channel Systems GmbH