Welcome to our user forum (read only mode).
Would you like to react to this message? Create an account in a few clicks or log in to continue.
Welcome to our user forum (read only mode).

Our forum runs in read only mode as an archive for solutions and problems (FAQ like).


Reading the (compliance) Voltage in Current mode

2 posters

Welcome to our user forum (read only mode). :: Technical Forum :: Stimulus Generators

Go down

Reading the (compliance) Voltage in Current mode Empty Reading the (compliance) Voltage in Current mode

Post  mrklab Sun Mar 17, 2019 9:06 pm

In my current mode application I would like to track the voltage over time to assess any drift in the impedance.

Is there a command in the API to read the currently used (i.e. compliance) voltage while in current mode?

I looked through the documentation but could not find anything.

mrklab

Posts : 3
Join date : 2017-05-30

Back to top Go down

Reading the (compliance) Voltage in Current mode Empty Re: Reading the (compliance) Voltage in Current mode

Post  Frank MCS Mon Mar 18, 2019 4:19 pm

I don't think this is possible, but I'll check with my colleagues tomorrow.

Frank
Frank MCS
Frank MCS

Posts : 188
Join date : 2008-07-14

Back to top Go down

Reading the (compliance) Voltage in Current mode Empty Re: Reading the (compliance) Voltage in Current mode

Post  Frank MCS Tue Mar 19, 2019 3:48 pm

Hello,
I was right, unfortunately. The STG can't measure the complicane voltage during current stimulation.

Frank MCS
Frank MCS
Frank MCS

Posts : 188
Join date : 2008-07-14

Back to top Go down

Reading the (compliance) Voltage in Current mode Empty Re: Reading the (compliance) Voltage in Current mode

Post  Sponsored content


Sponsored content


Back to top Go down

Back to top

- Similar topics

Welcome to our user forum (read only mode). :: Technical Forum :: Stimulus Generators

 
Permissions in this forum:
You cannot reply to topics in this forum