External triggering of a 32-channel system: LP filters needed?
2 posters
External triggering of a 32-channel system: LP filters needed?
Hello,
I want to trigger stimulation of a 32-channel system (consisting of 4 STG4008 devices) externally, using a single TTL pulse. I plan to send this pulse to Trigger IN of channel #1, and then have the SYNC Out of that channel trigger the remaining 31 channels.
Do I need to interface a separate resistor/capacitor low-pass filter to the BNC connector of each of the 32 channels to avoid ringing, as stated in page 57 of the manual?
Regards,
Nicolas P. Cottaris, Ph.D.
I want to trigger stimulation of a 32-channel system (consisting of 4 STG4008 devices) externally, using a single TTL pulse. I plan to send this pulse to Trigger IN of channel #1, and then have the SYNC Out of that channel trigger the remaining 31 channels.
Do I need to interface a separate resistor/capacitor low-pass filter to the BNC connector of each of the 32 channels to avoid ringing, as stated in page 57 of the manual?
Regards,
Nicolas P. Cottaris, Ph.D.
np_cottaris- Posts : 9
Join date : 2010-10-29
Re: External triggering of a 32-channel system: LP filters needed?
Dear Dr. Cottaris,
this is just a suggestion for a circuit that creates a propper TTL. You can connect the STGs to each other directly.
Frank MCS
this is just a suggestion for a circuit that creates a propper TTL. You can connect the STGs to each other directly.
Frank MCS
Frank MCS- Posts : 188
Join date : 2008-07-14
Similar topics
» Channel layout in filters in MC Experimenter
» Is the amplifier of the multi-channel system ac couple
» Trigger an external stimulator using MC Rack
» MEA set-up for brain slice analyzis: water bath needed?
» How to extract data of specified channel?
» Is the amplifier of the multi-channel system ac couple
» Trigger an external stimulator using MC Rack
» MEA set-up for brain slice analyzis: water bath needed?
» How to extract data of specified channel?
Permissions in this forum:
You cannot reply to topics in this forum