Problem with the new STG2008: Sweep light is on
3 posters
Problem with the new STG2008: Sweep light is on
Dear MCS,
I have recently purchased a new STG2008 stimulator. In the past, I used exactly the same device loaned to me by Scientifica. When I got our own stim, I just thought I would plug it instead of the previous one and it would work. However, when I switch the power on, the Sweep light turnes yellow even if the stim is not connected to the PC. Moreover, the PC and MC Stim do not see the new stim through the USB connection. Could you tell me what could be the reasons for these problems?
Many thanks,
Maksym
I have recently purchased a new STG2008 stimulator. In the past, I used exactly the same device loaned to me by Scientifica. When I got our own stim, I just thought I would plug it instead of the previous one and it would work. However, when I switch the power on, the Sweep light turnes yellow even if the stim is not connected to the PC. Moreover, the PC and MC Stim do not see the new stim through the USB connection. Could you tell me what could be the reasons for these problems?
Many thanks,
Maksym
mcs- Posts : 518
Join date : 2008-06-10
Re: Problem with the new STG2008: Sweep light is on
The internal circuit board had come loose during transportation. It was reconnected by our local distributors (Scientifica), and the device sent back to the customer.
mcs- Posts : 518
Join date : 2008-06-10
Re: Problem with the new STG2008: Sweep light is on
Do you have any feedback that STG2004 gives unstable voltages for a long term period? And do you know the best way to see and record signals from the stimulator except for a oscilloscope (because we can't record)?
faarisuman- Posts : 1
Join date : 2014-12-26
STG2004
Dear Fari,
an Oscilloscope would be exactly what you need. as an alternative you might try to stream the STG output into any DAQ system and plot the result. However this would add more components to the test and is not my first choice for such a test...
Thomas
an Oscilloscope would be exactly what you need. as an alternative you might try to stream the STG output into any DAQ system and plot the result. However this would add more components to the test and is not my first choice for such a test...
Thomas
Thomas- Posts : 49
Join date : 2008-06-03
Similar topics
» Error: STG2008 from Matlab
» Setup the memory layout of the STG 4008 using Matlab?
» Trigger continous recording and mark Light-On event
» STG2004 unrecognized by Windows7 32bit
» Problem about the MEA tool
» Setup the memory layout of the STG 4008 using Matlab?
» Trigger continous recording and mark Light-On event
» STG2004 unrecognized by Windows7 32bit
» Problem about the MEA tool
Permissions in this forum:
You cannot reply to topics in this forum